What hopper should I use with my warp?

[kingpen509]

I have a 12volt revvy with x-board & a Halo TSA which should I use? Has anybody been able to distinguish a preferance?

[MoeMag]

[PnueMagger]

Tsa.

[VFX_Fenix]

All about the Revvy FTW

[IcantBelieveit]

revvy owns all on a warp....although i hear a ricochet does well

[BigEvil]

I have a Halo w/victory board on my Warp. The warp has the 12v mod, and does a very good job of keeping up. Especially with the intellifeed link to the emag board.

Out of all of the hoppers, the VL's probably physically fit the best. I needed a 45* elbow for the hose with the warp.

[wanna-b-ballin']

revvy. the TSA is ugly and i dont think there is much of a difference performance wise.

[kingpen509]

Revvy it is and here she is:








Thanks yall!

[Lohman446]

I like the positioning of the Revvy door better for a warp style set-up. As to speed the Warp can feed without the revvy for short bursts so I would think you would be fine unless you are capable of laying down extended streams of 15BPS - which I highly doubt.

Its one of the reasons I don't take the new Velocity seriously. The door position sucks so much compared to my Empires (at least in my opinion for my use) that I would have a hard time with it.

[kingpen509]

I hear ya!

[Aslan]

sweet

I like that set-up. That's a nice looking gun. You've managed to get yours much tighter than I've gotten mine...I'll have to see if I can tighten mine up a bit.