Hyper frame good or bad for Classic valve?

[Nutsnyomowf]

Hey can any of you guys tell me the benefit of a CF hyper frame on a classic valve.Dont have the money yet to get a Xvalve

[buzzboy]

It really isn't a problem as long as you don't shoot over like 15 bps and you use HPA. Also I have read that it is better to use it with the supplied hyperframe on/off.

[SpitFire1299]

ULT is lighter though.. and i think even centerflag recommends it over theirs, because the hyperframe was pre-ult (I believe, correct me if im wrong).

[hitech]

ULT should be better. And I made a vid of a classic valve shooting paint at 20bps fullauto, so I think it works just fine.

[Nutsnyomowf]

ULT should be better. And I made a vid of a classic valve shooting paint at 20bps fullauto, so I think it works just fine.

can you link the vid?

[hitech]

Not at the moment. I could email them to you (about 3.5 megs each, 2 files). Send me a PM with your email address if you want me to email them to you.

[Arstron]

Not at the moment. I could email them to you (about 3.5 megs each, 2 files). Send me a PM with your email address if you want me to email them to you.

email them to [email protected] and ill post them on the net.

[Jaan]

I have one on a classic with the Hyperframe on/off and I'm shooting CO2 with a remote line. It shoots fine.

you have to watch out for the older classic valves since the depth of the on/off hole wasn't drilled to exact specs. If the pin is too short it will chew up the bolt.

[hitech]

email them to [email protected] and ill post them on the net.

The email was rejected. You can try here:

http://briefcase.yahoo.com/bc/[email protected]/lst?.dir=/Hosting&.view=l

[Beemer]

You can try here:

http://briefcase.yahoo.com/bc/larryd...osting&.view=l

Good job Hitech. Thanks I missed em last time around. So good, here they are again.

http://home.comcast.net/~beemerone/HitechHyper1.avi

http://home.comcast.net/~beemerone/HitechHyper2.avi

What reg and output is that at? Looks all OEM rail, body, valve. What bolt, on/off?

and thats a Classic Valve But dont tell no one

Peace Out

____________

[hitech]

That is a stock minimag. The tank is a preset PMI 68/3K. It has a level 10 bolt with the short spring (the middle & long spring will not work). The on/off is the centerflag on/off with their "long" pin.

[Dubstar112]

Mine ran flawless for quite some time. Flatline HPA and warpfeed with classic valve and I was never disappointed.

[Beemer]

That is a stock minimag. The tank is a preset PMI 68/3K.

Preset to what?

[buzzboy]

I'm pretty sure PMI tanks are preset to about 800.

[hitech]

Preset to what?

I've never measured it, but it should be around 800psi.