Posting here b/c need a fast answer

**going_home** · 05-18-2006, 07:43 PM

Xmod has its own thread

You would be better off posting this in the Xmod thread.

XMOD BETA Testers ONLY (Questions/Comments) - Automags.Org Online Forums

http://www.automags.org/forums/showthread.php?p=2153036#post2153036

Named after the IBM super computer, Deep Blue is headed by Tom Kaye, president of AGD. This forum is open to the public, but only high end technical subjects are allowed. If your posts don't cut the mustard they will be moved.

**master_alexander** · 05-18-2006, 09:49 PM

i dont remember much from my emag it it could very well be the noid setup... make sure everything is all good and working in there. If it will register BPS then its not a board problem, i would think... Check the battery too.

**Tao** · 05-18-2006, 10:59 PM

Originally posted by chip08

I need my Emag to be working by tomorrow morning and was hoping you guys could help. Its got the XMOD. The marker works fine in manual, but wont cycle in E mode. It will fire one shot in E mode if I fire a few times in manual first. It works fine in Practice mode and registers a bps. It also flashes that the trigger is registering when I am on the TRIG_ACE_ menu screen. The ACE is off. What is up? Is it the HES? I'm clueless and frustrated at the moment.

Try tightening the field strip screw in a BIT tighter with an allan key. (Don't go too tight). I have had a gun which would not hold the valve down tight enough to make proper contact with the sear by tightening the field strip scre by hand...