i got my new mag...and it wont work

[Skate And Paint]

ok well i guess thats not totally accurate, seeing as it does shoot. but i have to wait a good 5 seconds + before i can pull the trigger again, its like the pin takes forever to get back to position. and sometimes it just chuffs (i think is the right word?) and a little bit of air can be heard, and thats it. what do i need to do to fix this? do i just need to tune my level 10?

and on my trigger frame, im not sure wat kind for sure...its a dye one, should there be anything in the whole behind the trigger? like a pin? it has the pin holding the trigger...but theres also a larger hole there. ill try to get pics

and wen i was unwrapping it out of the paper the guy sent it in, two small metal discs fell out. im not sure wat they came from cuz i didnt see where they fell from. anyone know what im talking about/what they do?

help

[ttink]

ok well i guess thats not totally accurate, seeing as it does shoot. but i have to wait a good 5 seconds + before i can pull the trigger again, its like the pin takes forever to get back to position. and sometimes it just chuffs (i think is the right word?) and a little bit of air can be heard, and thats it. what do i need to do to fix this? do i just need to tune my level 10?

and on my trigger frame, im not sure wat kind for sure...its a dye one, should there be anything in the whole behind the trigger? like a pin? it has the pin holding the trigger...but theres also a larger hole there. ill try to get pics

and wen i was unwrapping it out of the paper the guy sent it in, two small metal discs fell out. im not sure wat they came from cuz i didnt see where they fell from. anyone know what im talking about/what they do?

help

If you have the same frame as me (dye single trigger) then i think that hole is for a safety assembly. I dont have a saftey in there but u can get them if u want. Some fields might require them however. I would try going down a carrier size on your level 10 as well.

[magman007]

If you have the same frame as me (dye single trigger) then i think that hole is for a safety assembly. I dont have a saftey in there but u can get them if u want. Some fields might require them however. I would try going down a carrier size on your level 10 as well.

go up a carrier, not down.

[jenarelJAM]

Yeah, you might have a too-tight carrier making your bolt stick to the valve. If you go down a carrier size, you will make the bolt stick worse, but if you go up a carrier, you will loosen it. This might not be the problem however, try it and get back to us.

Just checking, but is your tank outputing reliably?

[p8ntball72]

Do a checklist

Tank above 1500 or full?

Turn up the reg. {do you have a chrono?} If you have the air and a chrono crank it up and dial in your FPS.

Check all O-rings and OIL

Check on off pin length

Grease Reg piston

If all else fails sent to AGD or Tuna for a tune up..

[slade]

tighten the rear grip frame screw. sounds stupid, but it could very well be it. on ULE mags it usually has to be torqued down.

the discs are probably lvl10 or ULT shims.

[minimag03]

It sounds like your tank does't have enough pressure in it.

[BD_Paintball]

if you have a full tank try to go to a carrier size that is one bigger