How much voltage can a halo handle?

[mr.mag218]

anyone know what kind of voltage the halo can handle? see i have an emag foregrip on my devilmag, and a spare emag battery. so i figure i can hook up a few wires and run the halo off of my emag battery. the only problem is i dont know if the halo can handle 16 volts. Thanks AO -mr.mag

[onedude36]

It cant. Get a voltage regulator and take it down to 9 or so.

[mr.mag218]

any idea where i can pick one of those up?

[onedude36]

Digikey maybe? Im not remotely educated in electronics, so you might want to get a 2nd or 3rd opinion

[FiXeL]

An emag battery gives a voltage of 18 volts if i'm not mistaken. A halo board needs about 9 volts max. to work. You could go as far as giving it 12 volts, but some boards (cheeta boards) can malfunction on those high voltages. My halo has a V35 victory board and i'm using a 8.4v/700mAh battery pack. Works fine even when the cells give off 11 volts peak voltage fully charged.

[DaveSM]

Cheetah board works up to 35V. So with this board you should be fine.

[FallNAngel]

Cheetah board works up to 35V. So with this board you should be fine.

Uh... no... I believe 18 will fry it.

[Rudz]

Tag

yeah TAG retracted theyre previous claim, because a ton of boards fried, yeah the boards start acting dumb, i would know, i think i freid mine, stuoid TAG, good for nothing, anyways, "shedes" here on AO, did a wiring set up for me , with a heat sink, the harness powers both my halo and warp. easilly.