emag feednecks

[phizz]

I have a quick question, I was looking to get a CCM feedneck from LuisV for my emag, but I read somewhere that if you get one too short it won't work? I can't seem to find the thread where I read it, and I can't remeber what size it was, can anybody elaborate on this for me? Would like the shortest one possible that will work.

[11 Bravo]

I wouldnt see a problem with a short feedneck. It would depend on what body you have though. If its just a ule body, it should be fine.

[StygShore]

feedit

No problem on a standard ULE - if you had a Dalara or Karta, you can not get the no-pro feedneck, because it hits the body before it threads in all the way.



Styg

[Rudz]

heh

unless it was one of the rpg karta bodies like 11 bravos, and they were milled just a lil more for a sub zero to fit..

[grEnAlEins]

I have a quick question, I was looking to get a CCM feedneck from LuisV for my emag, but I read somewhere that if you get one too short it won't work? I can't seem to find the thread where I read it, and I can't remeber what size it was, can anybody elaborate on this for me? Would like the shortest one possible that will work.

It will work fine with a low/no-rise barring the karta case stated above. You were probably thinking of the thread about puting a low/no rise on an angel (which is supposedly bad ).

[StygShore]

angel

It will work fine with a low/no-rise barring the karta case stated above. You were probably thinking of the thread about puting a low/no rise on an angel (which is supposedly bad ).

Angel Roto breech made it so if the feed neck was too short you couldnt swing the breech open without hitting the cup in the feed.

Styg

[11 Bravo]

unless it was one of the rpg karta bodies like 11 bravos, and they were milled just a lil more for a sub zero to fit..

Nope that Karta body is direct from Deadly Wind and it has'nt been milled for that feedneck. It just fit with no problem. I did try other brands of no rise necks that didnt work, but the Sub Zero fit with no problem.

[StygShore]

orly

Roguefactor himself said that the sub-zero feed would not work on a Karta....


Styg

[11 Bravo]

^^^^ Well I dont know what it is then. I bought it from the Mag Smith. I'll have to go over there and see what I bought.
After checking his sight.---Well maybe Rouge will look at my mag "in the MOGM" and then tell us what it is. I know its one of his and it is a lo or no rise. He doesnt have the type that I bought on his site anymore though.
I am saying all this mainly to emphasize that that body was not milled to fit that feedneck.

[pennywise]

If you bought it from TheMagSmith, you bought a Sub-Zero.

I must say, the best damn feedneck - ever!

[phizz]

Thanks guys its for a karta body, I knew I seen something about them somewhere.

[mobsterboy]

The standard Karta design has 2 peaks on the north and south of the feedneck receptacle. These 2 peaks hit the bottom of the feedneck cup after a few turns.



If you bought it from TheMagSmith, you bought a Sub-Zero.

Shawn, he's prob thinking a strangler feedneck. Those have no problem going on the dallaras and kartas