X Valve Problems

[ricwhic414]

Ok well I am trying to install my lvl 10 on my Xvalve and I am having some problems
First of all when I put in the carrier that doesn't leak the sear will not reset.
Then when I change it to one that it will reset I have a leak.
Sometimes I won't have a leak at the beginning then I will shoot a little bit and it will start to leak a little bit.
And I am also getting bounce on the xvalve which wouldn't normally be a problem put at the tounry that I am in will not allow bounce so if someone could help me out I would appreciate that.
Thanks

[sTaLa]

Add shims to the carrier that does not leak but does not reset. Shims are there to make the bolt reset.

Usually, a longer on/off pin will kill bounce.

Hope that helps.

[ricwhic414]

Also the pin that the sear hits is getting stuck out like when I take out the field screw the valve is staying in the body because the pin is sticking out and holding it in

[punkncat]

Degas the marker. Pull the trigger with the safety off, THEN pull the strip screw and the valve will come right out.