Warp feeds on other guns

[wws2010]

I have an ion and was wondering where is the cheepest place to get a kit for one is.

[warbeak2099]

You'd need a PTP warpfeed. www.proteamdirect.com

[wws2010]

couldent i buy a an agd warp feed then buy this bracket

the link


Would this work to
The other link

[warbeak2099]

It's not about the bracket. It's about the elbow that goes into the feedneck. The AGD one is designed to fit over a smaller diameter neck than an Ion has. You need the elbow that comes with the PTP kit. It is designed to fit into a feedneck, not on the outside of it.

[wws2010]

It's not about the bracket. It's about the elbow that goes into the feedneck. The AGD one is designed to fit over a smaller diameter neck than an Ion has. You need the elbow that comes with the PTP kit. It is designed to fit into a feedneck, not on the outside of it.

so couldent i buy the agd only and buy the adapter seperately

[Toll]

All you have to do is dremel off the wee plastic bit that holds the screw and the nut and it will fit inside your current feedneck with a bit of help.

[MANN]

you will have to do something similar to this to fit inside your feedneck

[wws2010]

So all i need are these two things.

LINK #1

and

LINK #2

AND THEN IT WILL WORK. CORRECT?

[MANN]

you dont need link 2. (I dont think they have any more anyways) Link 1 has the clear elbo. You will need to cutt off the screw fitting with a dremel (or pm me and Ill trade you for one that is ready to go) and it is good to go

[Lenny]

Check THIS thread out. It explains how to rig a warpfeed to feed per trigger pull (like intellifeed on an Ion)

[wws2010]

Can you show me how to dremmel off the extra nut. Like the a before and after.

[VFX_Fenix]

You need -

This...


And This...

^^^
From PTP

[Toll]

That nut right there iswhat needs to be cut down. Basically just making it a circle.

[wws2010]

That nut right there iswhat needs to be cut down. Basically just making it a circle.

thanks this is great im getting my setup in the nextcouple weeks

[Tao]

Holy a PTP warp is $179!!!!