Okay.
Since NONE of these guns come anywhere close to having interchangable parts. I'd recommend the following.
1) Don't try to hybridize these guns.
2) Buy a DTI2 from Deadly Wind.
3) Buy an L7 Bolt for said Ion.
4) Buy a PPS Female Stab to relocate reg to trigger frame.
5) You'll need an adapter to replace the reg in the vertical ASA and a couple of straight macro fittings w/ line or an appropriate length of SS hose.
6) Pull the RIS foregrip off the BT4 and install on your Ion.
7) Buy a NDZ Cocker Threaded Breech to use the barrls from your DM4.
8) Of course Trigger of your choice and a Feedneck of your choice as well.
9) QEV if you don't already have one
10) A stock if that's your gig.
11) Board Upgrade if you don't already have one..
Finished. At least one part was used from each of the guns to make a whole new gun.

or you know... you could just send me some $$$, i think you owe it to me for all the hard R&D I had to do to answer your question.
Since NONE of these guns come anywhere close to having interchangable parts. I'd recommend the following.
1) Don't try to hybridize these guns.
2) Buy a DTI2 from Deadly Wind.
3) Buy an L7 Bolt for said Ion.
4) Buy a PPS Female Stab to relocate reg to trigger frame.
5) You'll need an adapter to replace the reg in the vertical ASA and a couple of straight macro fittings w/ line or an appropriate length of SS hose.
6) Pull the RIS foregrip off the BT4 and install on your Ion.
7) Buy a NDZ Cocker Threaded Breech to use the barrls from your DM4.
8) Of course Trigger of your choice and a Feedneck of your choice as well.
9) QEV if you don't already have one
10) A stock if that's your gig.
11) Board Upgrade if you don't already have one..
Finished. At least one part was used from each of the guns to make a whole new gun.

or you know... you could just send me some $$$, i think you owe it to me for all the hard R&D I had to do to answer your question.



Comment