classic valve vs. x-valve air system question, help

[GSKRAP]

my tank is a 68/45 with a fixed output of 750 psi, which i dont think is ideally suitable even for my classic valve, it should probably be around 800. it works fine, however. no problems.

anyway, when i upgrade to x-valve (and ULT soon after that) will this tank still be ok? yes, as soon as i can i will upgrade to something with adjustable, higher output pressure, but is 750 ok to run the x without any problems?

[cyrus-the-virus]

I ran my X-valve on around 600 PSI without any problems. I just didn't get as much reativity out of it.

[Chronobreak]

youl be fine with your tank, might need to fine tune your setup though afterwards

[MisterBones25]

if your looking to get alot of bounce from your ult then go to an adjustable tank, but if your just looking to be able to shoot, that tank should be fine. buy the x-valve first and see if it works that way your not wasting money that you dont need too.

[egb groupie]

At lower PSI, the X-valve will also have more consistency shot-to-shot over the chrono vs. a higher PSI.