Can't get the board out of my Hyperframe!!!!

[punkncat]

I am trying to trade boards with a member here on AO. I cannot get the board to come out of the frame.

There is a clearance issue between the mode buttons and the lip on the forward side of the frame. I cannot get enough room to push the board forward and have the buttons clear their holes. I have tried pushing the buttons, slightly wedging it with a small screwdriver, even took off the other side grip panels and attempted to push it out from the other side.

Is there something I am missing about getting this board out?
Its an original 13BPS board and evidently has never been removed. Obviously it is in there now so it had to be out at one time.
HELP?


...oh and before you ask I have removed the two screws....

[smilestyler]

Try lifting the forward side out first. That's all I can think of. It does look tight in there.

edit; the white buttons are not part of the board, should it not wiggle straight up?

[mobsterboy]

pic? taken the board out? Move around your capacitor and see if you can slide it up and out or over and out