Back when the hAir trigger was all the craze/when PTP took over and said they were working on a oneu frame there was talk about a cocker frame in the works as well. I was wondering why there hasnt been anyone doing cocker pnueu-frame conversions. It would take a little more work than a mag conversion but it could be done. I searched around a little bit and so far havnt really found anything. Anyone have any info or insight on this?
-
-
I was actually designing a completely pneumatic 'cocker. It would need a custom made 5-6 way valve though. Or you could use 2 4-ways. Either way, I'm still working on the design. Picture a mech Osiris. -
Um, aren't cockers pneumatic to begin with?
Comment
-
Funny guy....
Of course cockers are pneumatic, you know i mean a pneumatic trigger.Comment
-
Seems as though it would really take a while to time. But then of course it could be locked into place but the initial would be a b****.Comment
-
Well there is the easy way...
Use the normal trigger movement to actuate the three ways and have a pnuematic cylinder to actuate the sear..
or the hard way...
Have pnuematics actuate EVERYTHING that is normally "Mech" on a cocker and just have your trigger actuate two very short throw 3 ways for thisWild Geese - Coney Isand White Fish - ECA
ECAP - "Making players dreams other players nightmares"Comment
-
there were some kits that were press 2000 IIRC
it would be easy to do just not sure how well it would fit togeather insie the frame. i had figured it out in my head at one point because i was really waiting fort the pneumatic cocker frame when there was talk about it.
thinking about it again im pretty sure it would be very easy
-mattComment
Comment