Lukes stock class minimag body on ebay

[Merce]

http://m.ebay.com/itm/281632788372

[jame4091]

I hate powder coating, the seller should have just hit it with some wally world spray paint. Would have looked just as good!

[Merce]

Me too. Wonder how hard it'd be to refinish

[OPBN]

Pretty sure it is Sean Chips old marker and actually was very nicely done.

[zulubravo44]

Totally being nitpicky, but doesn't the spring make it not actually stock class?

[keiko_819]

so stock class doesn't have to be pump? never knew that...

[Jaan]

Totally being nitpicky, but doesn't the spring make it not actually stock class?

You're right. However the spring looks easy to remove. If you're really nitpicky, stock class rules vary greatly sometimes. Some stock class rules say you can't have more than one ball over the feed port vertically at a time, some say you can have no more than 10 vertical, and 15 horizontal etc. A sleeve would be easy to make to cover the hole for rock and cock.

so stock class doesn't have to be pump? never knew that...

Pump mags are common enough. Easy to put a CCI phantom 12 gram changer or the like on a Mag. Again, nitpicking stock class rules, many say you have to have a 12 gram that passes through threads (no drop outs). I was getting 20 shots from a 12 gram in semi at 275 fps without any mods.

[zulubravo44]

Pump mags are common enough. Easy to put a CCI phantom 12 gram changer or the like on a Mag. Again, nitpicking stock class rules, many say you have to have a 12 gram that passes through threads (no drop outs). I was getting 20 shots from a 12 gram in semi at 275 fps without any mods.

I think keiko was trying to point out that the body is listed as stock class, but it isn't pump milled. It's more like a mini-sydarm than anything.

[keiko_819]

^^^correct

[JonM]

It's mine now.

[JonM]

In case anyone is wondering, here's how it turned out.