There will be much polishing to follow... has anyone polished one of these yet? I know I've heard of several people talking about it, but I've not seen one yet... I suppose I should just get to scrubbing...
-
-
Pneu in the works by cyberave
Comment
-
If you guys dont mind me asking, did you all who put the tickler inside the frame need an 1/8 npt female to 1/8 npt male adapter to make it to the cp direct mount or was it able to make the distance by it self.
ThanksComment
-
Originally posted by NoremacTheImpaler
no,,, all that needs to be done is counter sink the hole in the air on/off and use a oring between the frame and direct mount...
Comment
-
Thank you for the replyOriginally posted by BREAD_DA_PAINTERno,,, all that needs to be done is counter sink the hole in the air on/off and use a oring between the frame and direct mount...
Comment
-
Originally posted by NoremacTheImpaler
no problem... I found these pics of my V1 frame maybe can help also...
TOP OF THE DIRECT MOUNT
THis is what it look like installed
Comment
-
Bread, great pics!!
Is there an actual DIY guide floating around on how to do this? I know that it looks easy enough but some of us first-timers need a little hand holding.
I've also noticed that to perform the same job on a Chimera frame, a little bit of cutting is necessary. Can this be done cleanly using a Dremel or is this better handled by someone w/ proper machining tools?Comment
-
cyberave has a diy thread on BEO that is great. All i have ever used is a drill and a dremel.Originally posted by TwilightGBread, great pics!!
Is there an actual DIY guide floating around on how to do this? I know that it looks easy enough but some of us first-timers need a little hand holding.
I've also noticed that to perform the same job on a Chimera frame, a little bit of cutting is necessary. Can this be done cleanly using a Dremel or is this better handled by someone w/ proper machining tools?
found it....
Comment
Comment