Introducing the Micromag 2009

[BigEvil]

In case anyone was wondering, the stock emag pin seems to work fine in my micro e. You won't need a really short one like the older Micro Es. I don't have a standard 2k9MM, so I have no idea what pin will work in that for the mechs.

[ZoomZ@PTP]

I set the parts in place to snap this pic , nothing is assembled .

Gloss black and grey to to the anodizer tomorrow .

[Pullman]

Ooooh Shiny!

[maniacmechanic]

In case anyone was wondering, the stock emag pin seems to work fine in my micro e. You won't need a really short one like the older Micro Es. I don't have a standard 2k9MM, so I have no idea what pin will work in that for the mechs.

^^^ you take all the fun out of it
Did you get a raw one ? ideas on anno yet

Got my Matte Black stuff today , allready running air through it , needs a little tinkering on it , vert feed pic's tomorrow , more likely than than not it will end up with a warp on it though ( should we start a Pic thread for these ?? )

[BigEvil]

[Tracy_ptp]

NICE!!!!! I love it!!

[Uranus633]

So is it just the raw's that are getting shipped right now?

[SummaryJudgement]

Can't wait to see grey...BigEvil is making me think I made a mistake though. Especially since I didn't send in my lowers to be matched

[TheePsycho]

Curious question I know barrels get honed, but do body tubes and breaches?

http://www.flexhoneblog.com/2009/07/levigated-alumina-flex-hone-used-for.html

[chopper duke]

I hate you so much right now Scott.

[vf-xx]

Edited for better pictures and your drool enjoyment.

[zondo]

^^^

Well now... I was wondering how a 90* frame was going to look. That J&J Barrel looks nice on there too.


How is it shooting??

[vf-xx]

Haven't shot it yet. Need to fix some tank o-rings and get the right length front grip screw as well.

[BigEvil]

http://picasaweb.google.com/novaprim...eat=directlink

Looking good Frank.

[maniacmechanic]

well here's mine ;