E-Mag Battery Pack ASA Manifold

[luke]

What is the microline fitting for?

If you want to run your air supply into the housing you will use the port where I have the micro fitting. But it's a manifold, so you can set it up anyway you like. I set it up the way I did just so you could deduce its possible uses.

The left, right and two bottom ports are all attached together, so if you supply air to any of the 4 ports you will have air at the other three, use your imagination.

[afortuna]

If you want to run your air supply into the housing you will use the port where I have the micro fitting. But it's a manifold, so you can set it up anyway you like. I set it up the way I did just so you could deduce its possible uses.

The left, right and two bottom ports are all attached together, so if you supply air to any of the 4 ports you will have air at the other three, use your imagination.

Thanks for the reply. I'll now have to go find my imagination.

[luke]

Thanks for the reply. I'll now have to go find my imagination.

LOL, I wasn't giving you a hard time.

[Warwitch]

The original concept started with FiXeL as far as I know. I'm not sure if anyone did one before him. Just for the record, I did run this project by FiXeL before I started it. Also, I was contracted by Dend78 to get the project on wheels.

Actually the original idea of a stealth LPR inside a battery pack was mine.

Das Fire-Mag

Im really gald to see everyone stepping it up to the next level!

[Dend78]

Actually the original idea of a stealth LPR inside a battery pack was mine.

Das Fire-Mag

Im really gald to see everyone stepping it up to the next level!

yeah yeah step in with an old thread and think ya run the place

actually thats the first time ive seen that thread, that was a cool setup.

[Dend78]

well i got mine in yesterday i must say great work Luke it looks great, it turned out great, only issue i have now is i gotta get my lazy arse in gear and finish my project mag.

i also picked up some other random parts from emag panels and a selector switch, i also had him fix up a rail to go with this block here is a pic of my start on the mag, if its silver he did it aside from the hacking inside the frame, ill get some finished pics up when its done

http://i238.photobucket.com/albums/ff34/Dend78/100_0304-2.jpg

http://i238.photobucket.com/albums/ff34/Dend78/100_0303.jpg

[luke]

Sweet!
Don't forget to locktite the set screw in.

[pk5]

Hey Luke

do you offer polishing on these?

[luke]

I can polish one for you for a small fee.

[drewkroeker]

Luke I saw a thread a while back that says you (I think it was you, anyway) were fixing warp feeds and now I can't find that thread. I have a warp feed that needs to be fixed. The battery harness for the 9 volt has the black wire snapped off. It is also disconnected from the circuit board. If I could ship it to you and get it fixed, that would be awesome.

Thanks,

Drew

[luke]

I'll send you a PM..

[afortuna]

I want to buy one, but need the battery pack!

[luke]

I want to buy one, but need the battery pack!

Tunaman?

[Dend78]

also you may talk to Tracy_PTP i think they had a few in stock they were short on one piece though i cant remember if it was tops or bottoms though

[Tracy_ptp]

also you may talk to Tracy_PTP i think they had a few in stock they were short on one piece though i cant remember if it was tops or bottoms though

I have plenty of middles and tops. I am out of bottoms!!