Micromag Foregip Order

[luke]

I have a MM2K, I have S, reverse S, and double horizontal tapered ends. If you guys want something diffrent I need a sketch with a suitable layout. I need it asap I can get it programed, cut and shipped.

[luke]

Are you talking about this body style?



Does the groove have a curved/filleted bottom? (U bottom)??

How wide is the groove?

How much space between the grooves?

[OPBN]

Yes, that is the body style I am referencing. I would say 4-5 cuts similiar in size, depth, shape etc as the on the body. Maybe someone else has a different opinion. If it's a PITA, don't worry about it. I was fine with the plain style. Once you start giving milling options....

[luke]

But I need these questions answered:

* Does the groove have a curved/filleted bottom? (U bottom or is it flat)??

* How wide is the groove?

* How wide is the space between the grooves?

* Can anyone verify the groove angle, is it 45*?

[OPBN]

But I need these questions answered:

* Does the groove have a curved/filleted bottom? (U bottom or is it flat)?? --Curved
* How wide is the groove? -6.29mm
* How wide is the space between the grooves? 6.09mm
* Can anyone verify the groove angle, is it 45*? - I used a framers tool and it does seem to be 45*

Sorry, I thought you had an earlier Gen MM body to measure. If you need, I am willing to send mine in to you to double check my measurements.

[luke]

Thanks that should work, no need to send yours in.

I'll work on this tomorrow and get some final pictures up so we can get a final tally.

[rseb4agze]

Thanks that should work, no need to send yours in.

I'll work on this tomorrow and get some final pictures up so we can get a final tally.

If its not to much trouble could also do a rendering of the slots being straight instead of angled like the emag bettery covers?

[Jiker]

I'll have to see what the mock up of the gen 2 grooves will look like.. I may have to reconsider getting it plain..

[luke]

OK guys I've updated the options (see first post in this thread) please post here for which one you want.
Please do not ask for changes or additional options, the design stage is over, I want to get these done and out the door.

[OPBN]

Make mine Gen 2 milling.

[rseb4agze]

Put me down for the Gen 2 milling

[Jiker]

Tough decision - they all look soooo good.. I think I'm going to have to go with the gen 2 milling.

[luke]

Tough decision - they all look soooo good.. I think I'm going to have to go with the gen 2 milling.

Well you could always buy two.

[rseb4agze]

Maybe in the near future you could also offer these foregrips for am/mm or rt style rails?

[luke]

Maybe in the near future you could also offer these foregrips for am/mm or rt style rails?

Dont know about down the road, we'll see, but you can get one today.