Angel feedneck to empire feedneck adapter!!LIMITED RUN

[river031403]

Another one sold and shipped today

[river031403]

Another one sold and shipped I have 2 left

[Cali_Mag]

So I see someone else has there's attached to a tac-one body. I have to caution users that this adaptor can screw in so far on some tac bodies that it won't catch the empire feed. On my body atleast I almost got the adaptor stuck.

Use a some Loctyte, nylon, or some elec. tape to tighten up the threads so it keeps more of the clamped on portion of the adapter risen more. Im going to put a thin layer of griptape or rough up the metal a bit where the empire clamps on as well, I feel like it slides on it bit even fully tightened on, just don't wanna break the plastic of the empire loader.

[river031403]

Zero issues here cycles fine

[Sk8ermog]

Yeah I had the same problem. I just put the adapter on the spring feed first and then screwed the whole thing onto the body. Fits well but shows just a few threads from a side view. Can't really help it without making these adapters a little taller, but then that would defeat the whole point of making them so small. I don't mind it. Just have to decide if I want the tube facing forward or backwards.

[dano_____]

So I see someone else has there's attached to a tac-one body. I have to caution users that this adaptor can screw in so far on some tac bodies that it won't catch the empire feed. On my body atleast I almost got the adaptor stuck.

[river031403]

Ok all are showing delivered for the exception of:
1-Canada ICS Los Angeles customs/sort facility
1- Finland ICS Los Angeles customs/sort facility
Thanks again guys!

[SoulCoffin]

not yet. I don't anticipate i'll have a feeding issue. just wanted to make sure it's all good.

[river031403]

quick question... should it be screwing down through all of the threading? mine tightens up and stops maybe a little past half way through the threading.

These are exact replicas of the prototype I had.Every single one of these were all placed on my warp left ule body to insure they were in working order I didn't have any issues nor should you. Have you shot it yet?

[SoulCoffin]

quick question... should it be screwing down through all of the threading? mine tightens up and stops maybe a little past half way through the threading.

[river031403]

Nice!

[SoulCoffin]

[Donut SD]

Mine came in a couple days ago, haven't done the install yet. Thanks!

[SoulCoffin]

I was watching yours go all around east coast.

ha, better than being completely lost

[river031403]

finally got mine. i'll post pics of my new setup when I get home

I was watching yours go all around east coast.