Z2 Grip Frame

[luke]

This might be cool, add some arc to the lines and it would be a fine line engraving..

[awo702]

I always liked this

[ATTACH=CONFIG]99735[/ATTACH]

I dig that too. Subtle, not too busy.


Sent from my iPhone using Tapatalk

[luke]

If you guys can settle one a single pattern I'll do it for free for anyone on the list (That wants it).
So throw some ideas out there, I would prefer some type of geometric pattern.

[bowcycle]

the staggered lines are cool. I'd lengthen them a bit so that the top and bottom ones extend a bit closer toward the end of the panels and the middle one lengthened just to keep the look. and if you wanted to get fancy and put a little "Z2" inside a hexagon at the bottom rear of each panel, that'd be pretty sweet.

[luke]

One more, again it would be fine line engraving

[luke]

the staggered lines are cool. I'd lengthen them a bit so that the top and bottom ones extend a bit closer toward the end of the panels and the middle one lengthened just to keep the look.

I've done that before>

[bowcycle]

I've done that before>

Yup. That's the engraving I had on my old Z panels. Maybe spread a bit wider across the panel this time.
Again, the design goes with almost any build.

Also, I realize I'm talking a lot, but I really will go with anything.
The big diamond is also cool. I'm trying to imagine it slightly parabolic so it kind of flows with the curve of the trigger.

[awo702]

I've done that before>

[ATTACH=CONFIG]99738[/ATTACH]

[Walking Stick]

I like what's on the green Z, it's along the vein of what I was thinking in my sketch 1 above.

However, maybe connect the central line to the others with a short diagonal? Connecting them actually makes it a combined, stylized, elongated Z and 2.

[ikillforwork]

I'm going to say yes to this also. Sent from my SM-G955U using Tapatalk

[luke]

Maybe spread a bit wider across the panel this time.

I agree, definitely wider spacing but also a little shorter

[luke]

So we're on our way, LPR housings were machined yesterday and I started the first and largest program on the frames this morning. I'll be running that first program for several days. Still a ton of work to do but I'll stay on it 7 days a week until it's done.

I am making extra so these will be a stock item.

[djinnform]

can't hardly wait for mine!

[Walking Stick]

So this is a mockup of the previous design like on the above green Z.


How about just two extra little lines like this?

[luke]

How about just two extra little lines like this?

I like that, I can see the "Z2" in it.

You guys decide, just don't take to long.