Aluminum Emag Switch

[luke]

I'm thinking about doing more, but not this design...

[Sajjad]

If you decide to make more (new or old design) put me down for 2xBlack and 1xRed.

Thank you.

Sajj.

[luke]

If you (and anyone else) will to pre-pay I'll make more.

It will be about 2 weeks (probably less) because I will need to order material. It will be a different design because I had some trouble making these, the little buggers were hard to keep in the vice.

[Empyreal Rogue]

I'll pre-pay for one. Maybe two if the price stays the same.

[luke]

Cool, here's what I'll do, the new switch will be $12 each for pre-orders. No refunds unless I cancel the run (which is extremely unlikely). The wait will be very short as usual.

Don't ask for pictures because I'm not sure what I'm going to do, I'll decide when I step into the shop. (as usual)

Available in

RED
BLUE
BLACK
RAW

Screw not included.

PM your order, include quantity and color.

Thanks

[luke]

OK guys these are going to happen, the orders are coming in. I have a design in mind that I think will be cool and different.

I'll check my inventory tonight and place an order for materials if necessary.

[luke]

Thanks for the orders guys. Keep-em comming.
It will speed this along.

[rifleman wi]

plan on makin any extra or only pre-order?

[luke]

Yea, but they will cost a little more..

[luke]

Update:
Material is on order. The project running a little behind because of a delay with the material order, but not very long.

Can someone with a set of calipers measure the "height" of the screw head on the emag switch and post here?

Thanks

[MANN]

...............rambling................cant find an allen head.....................there it is..................

.103"

Edit:

[luke]

Cool man, thanks!

[Russ]

PM sent

[luke]

Invoice sent

thanks

[Ruler_Mark]

ill take a black one,, invoice to [email protected]