Some nice mags and a few other rare/old guns

[bigbthebenji]

First up is the Ripper mag. This mag has a matching Ripper body and rail, a X-valve w/ LVL 10, a carbon fiber foregrip, a J&J barrel, a CP on/off, and a custom UL frame with hybrid grips.

This gun ripps. I've had it going 16+ with the RT. Only problem is the bolt will occasionally not reset.
The LVL 10 needs some tuning to correct this problem but I don't have the extra carriers.

Price - $585










NICE Automag RT classic. It has a benchmark frame and Dye Grip and is pretty much just stock. Stock barrel, LVL 7 bolt kit.

Price - $225









Lot of nibbles on this last time I had it up. Someone gonna bite this time?
Rare purple VMX. Shoots well and is in great condition other than a ding or two.

Price - $160

[bigbthebenji]

Mod 85 Fully auto. Comes with 1 clip as shown.

Price - $275








Gloss Green Carter Comp with

-L stock
-wood Grips
-Matching trigger shoe
-Sight rail
-Open class body
-CA adapter
-Just got a new cupseal and shoots 280fps

Price - $425
















Green/Chrome Carter Comp

-Milled bucket changer
-Milled rail
-Milled front block
-Milled pump handle
-L stock NOT INCLUDED
-Wood grips
only needs a feed tube



Price - $400








Palmers Typhoon without frame, untested - $215

[bigbthebenji]

AKA Splat Attack Revenge V1
-No leaks, but does need tuning
-Good condition


Price - $450











NW Savage pump. Just replaced a leaking seal and she is shooting great. Has autotrigger!

Price - $200











Next one up is simply awesome. It's An autoresponse Gen 1 micromag in Splash. It's got a 68 Automag valve and a non matching ASA, but other than that, it's all matching. It works perfectly and will come with grips. The tank matches but I believe was done aftermarket because the date is much later than first gen micromag dates (thanks for the info Dan). Only thing bad on this gun are the detent screw holes which are pretty messed up and don't hold it in, so that will need work.

Price - $450











Brass Eagle Barracuda. last I aired it up it had no leaks and shot well. Is pictured without a feedneck, but I filed one down from another gun (thanks again Bacci) and press fit it in place. It could use some JB weld or similar to lock that feedneck in place. Sold as is.

PRice - $150









1 of a kind Emag. Custom made E-frame based off a hyper frame. Takes 2 9 volts in the grip, has the on/off, grip, frame, rail, all one piece. Has wood grips on the frame and a custom piece under the barrel. Comes with an OTP barrel. Right now it has a classic valve in it, but I can swap an X-Valve into it with level 10 for an additional $145. The gun will need valve/board tuning before it can hit the field. I sent it out to get Tech'ed and it came back just puffing air.

Price - $500