[Sold] Automag: X-Valve, ULE Body, Intelliframe -- Updated 9/14/18

[nak81783]

SOLD

$432.85 shipped and PayPaled firm. No parting.

X-Valve has Level 10 and RT on/off.

Also included are Level 10 spare parts, extra bumper, extra detent, rebuild kit (all o-rings within valve and split PTFE washer for regulator pin assembly), extra safety ball detent, and CHOICE of

CCM feedneck and Shocktech drop OR ULT on/off, NOT BOTH.

[scootdogss]

Hey buddy, in interest in the mag. Just curious what shape it's in? Have you played with it lately? Any leaks? When was last time you replaced any seals?

Let me know. Thanks
Scott

[nak81783]

It’s in very good condition. If you want more pictures, let me know. I let my 6 year old son put about 100 rounds through it a couple weeks ago. It shot fine. I keep seals on hand, so I just replace them as needed. It is my backup, but I run a couple drops of oil through it every so often even though I don’t play with it much. There is an occasional small leak out the side vent hole. This is because I use a single turn split PTFE washer instead of a solid (unsplit) one on the regulator pin assembly. It’s always just been easier for me to maintain it that way. Depending on how the split washer settles when gassed up, weather, orings, oil, etc, it may slightly leak. It has never affected velocity or made any noticeable effect on shots per fill. If it bothers you, it’s an easy fix. Just buy and install the right washer.

I’m only selling because I’m slowly (and very reluctantly) beginning my departure from paintball. Limited free time, babysitters are expensive, frequently not enough players show up when I am able to play, taking a toll on my knees and back, etc.

[knownothingmags]

can i get next in line

[nak81783]

can i get next in line

I haven’t received any offers.

[scootdogss]

PM sent

[nak81783]

Replied. Still for sale.

[nak81783]

Sweetened the pot for a marginal cost increase.