"Need cash for Anno" sale!

[OneSelfLost]

Hey everyone,

I need to scrap together a few bucks to go towards a project, specifically for anno. If I can liquidate some extras, it would be super helpful right now. I will probably toss a "bonus item" in the box too if you buy something

Qloader kit, mostly new, comes with a whackload of adapters and brackets (Swear I have more.. I'll dig for em) SOLD



BNIB KAPP foregrip (mark on lower left is reflection), 2 BNIB Shocktech drops. All together for $50



BNIB Cocker bolt, pin, and lightly used back block $25



More to come..

[yadoo]

Pm inbound on q loader

[Ff33gfd]

Is that cocker bolt for a 2k3?

[OneSelfLost]

Yadoo, replied.

Ff33gfd, as far as I can tell, yes. I'll take some measurements for you. Only comparator I have is a P-block which doesn't help.

[OneSelfLost]

Is that cocker bolt for a 2k3?

The center of the pin hole to the tip is 5-1/8". The hole position doesn't look like it would fit a full block 98, and the back block on there is an 01. My best guess is that this is for a 2k+, but someone would have to verify that.

[Ff33gfd]

If someone gets on here and confirms its for a 2k+ cocker then ill buy it.
Lmk
Thanks

[OneSelfLost]

If someone gets on here and confirms its for a 2k+ cocker then ill buy it.
Lmk
Thanks

I've asked the folks over on CC.. even though half are here too haha

http://customcockers.com/forum/showthread.php?63816-Is-this-a-2k-bolt&p=517343#post517343

[OneSelfLost]

If someone gets on here and confirms its for a 2k+ cocker then ill buy it.
Lmk
Thanks

Confirmed 2k+