Looking for Intelliframe Blade Triggers & Emag Rail

[audioSLAVE]

Looking for a couple stock blade triggers from intelliframes that might be kicking around in parts box after people have upgraded. Also looking for a clean Emag rail for a project. Thanks in advance.

[Nobody]

No triggers for you but i got these rails.




The top is not ULE milled and has some scratches on the drivers side.
The middle is dust or flat black, the additional cuts do not effect anything, got it that way.
The res smear is warp left cut, very clean.

[audioSLAVE]

No triggers for you but i got these rails.




The top is not ULE milled and has some scratches on the drivers side.
The middle is dust or flat black, the additional cuts do not effect anything, got it that way.
The res smear is warp left cut, very clean.

Thanks for posting. Unfortunately, none of those will work. I want to cut it back to Automag length so anything ULEed won't work.

[luke]

If all else fails we can machine one from a slug. LMK

[Nobody]

Thanks for posting. Unfortunately, none of those will work. I want to cut it back to Automag length so anything ULEed won't work.

The first rail in the pic is not ULE'd. Just sayiny

[audioSLAVE]

The first rail in the pic is not ULE'd. Just sayiny

Yeah, I was looking to avoid any extra holes except for sight rail.

[audioSLAVE]

If all else fails we can machine one from a slug. LMK

Will do, this will end up in your hands one way or another.

[going_home]

http://www.automags.org/forums/showthread.php?273533-Katana-Trigger