WTB pump milled rail

[Riddler236]

Preferably pretty clean. Will buy an entire marker if needed.

Working on a pump build.

[luke]

If you have a rail you can get it machined.

[Riddler236]

Oh, right, silly me... What's your current turnaround?

[luke]

Less than a week.

[captian pinky]

Luke are you using agd's spec or something else like rainman?

[Laku]

Luke are you using agd's spec or something else like rainman?

I know the answer to this.

AGD spec.

[captian pinky]

I know the answer to this.

AGD spec.

while that was my hope. I was checking because everyone thought rainman was doing them to agd spec too and he isn't/wasn't.

[Laku]

while that was my hope. I was checking because everyone thought rainman was doing them to agd spec too and he isn't/wasn't.

I seem to recall that was originally discovered when Rainmans kits had problems with Luke's rails? I think it was that Rainman used thicker pump rods that sometimes bind with the rail.

I have older generation Rainman pump kit that does how ever work with Luke's Armada rail.

[luke]

Luke are you using agd's spec or something else like rainman?

AGD spec only, as it should be.

[Riddler236]

Ah, crap. What i have on hand at the moment is an ancient Rainman pump kit. I'll dust off the calipers and check the OD on the rod... What am I hoping to see?

[luke]

AGD pump rods are .110 diameter, I machine the slot at .135" wide so you really should be fine.

[Riddler236]

Ok, will check my kit this evening, thanks. So long as it checks out, I'll be zipping my cleanest rail off to you early next week.