WTB LAPCO Feedneck

[Zone Drifter]

Looking for a LAPCO universal vertical feed-neck, as they've been out of stock forever.

I cannot use my marker without one, the plastic spyder ones suuuuuck.

[Nobody]

[going_home]

I wonder if this could be adjusted to work, maybe with shims ?

https://lukescustoms.com/feed.html

[Nobody]

I wonder if this could be adjusted to work, maybe with shims ?




https://lukescustoms.com/feed.html

No, because the collar that would screw onto the body would have nothing to hold onto, by slipping it over the feedneck. What I am doing it to use a proper clamping feedneck, and to use the original feedneck as the adapter since it is intragal to the body.

[going_home]

Cut the threads off, cut the coller so it can get smaller, and use it as the shim I mentioned.

There you have it.

Worth a shot, nothing else to use unless Simon makes something.

[Nobody]

Cut the threads off, cut the coller so it can get smaller, and use it as the shim I mentioned.

There you have it.

Worth a shot, nothing else to use unless Simon makes something.

Then you have the feedneck being to big to fit the collar and it rattling around loose. You might as well use a piece of hose and a clamp.

What the OP is trying to do is have something secure and strong, not having a double hack method.

[luke]

Looking for a LAPCO universal vertical feed-neck, as they've been out of stock forever.

I cannot use my marker without one, the plastic spyder ones suuuuuck.

I'm guessing you're wanting to do something like this? My feednecks clamp down tight in a setup like this without any mods.
Feedneck.JPG

That said, a few minutes with a file or a mill to remove the little ring would be more ideal.
Feedneck cut away.PNG

The lip is very small
Feedneck lip.PNG

[going_home]

Thank you

[luke]

de nada

[Nobody]

The spider feedneck is much thinner than a mag feedneck. I don't think that your feedneck will work. I could be wrong but I am pretty sure I am not. That is why the feednecks needed a 1 off special feedneck adapter/elbow.

[Zone Drifter]

The feed tube I'm trying to fit for is .875 in diameter. The same 7/8 feed-neck that spyders use. It's for a forgotten marker that the threads are no match for any feed-neck that i know, my thread gauge is closest at 27 tpi, but it looks like 26 or possibly 25 tpi but certainly not 24. Unless you guys know the thread per inch of other feed-neck types then IDK myself. I haven't been able to match it up with any others yet.

[luke]

Gotcha, I thought you were looking for the Spyder slip-on feednecks. Sounds like what you really what you need is a 26tpi threaded neck ring

[Zone Drifter]

Gotcha, I thought you were looking for the Spyder slip-on feednecks. Sounds like what you really what you need is a 26tpi threaded neck ring

Yeah pretty much. FYI, its for an Inspire BFG. Also known as TG101 by Air Challenger, a Taiwan based supplier that also did the MG-7. Likely a 7/8-26 tpi threading but i don't know what other markers use that. It just came with a 7/8 neck with separate clamping adapter like the old vert spyders.

[Olsson]

I may be able to help you out here. However, the key word is may, so don't get too exited just yet. Does it have to be a LAPCO feedneck, or are you OK with any clamping feedneck fitting a BFG, as long as it is in aluminum?