Are doubble finger triggers made wrong???

[Hacker240]

the entire point of having a double trigger it to gain leverage. IF you were to make both the top and the bottom parts of the trigger travel the same distance then you would lose all leverage, and it would be jsut like a having a longer single finger trigger wouldn't it?

[MeLoveMagsLongTime]

Originally posted by Hacker240
the entire point of having a double trigger it to gain leverage. IF you were to make both the top and the bottom parts of the trigger travel the same distance then you would lose all leverage, and it would be jsut like a having a longer single finger trigger wouldn't it?

Actually, before the advent of electronic triggers, that would have been the point for me. Now I shoot electronic and the goal is to have the quickest ROF possible. For me, the double-finger trigger gives me more possibilities for the perfect finger position. You may be surprised how different fingers/positions can affect how you fast you can pull the trigger(like the trigger on the IR3). Personally, I use my middle finger, inside of the knuckle nearest the end of the finger resting right on the "hump" in the middle of the trigger.

With a "rocker" type trigger the idea would be like this... 1. Pull trigger with your index finger. 2. Release index finger and simultaneously pull with the middle finger. 3. Repeat

Theoretically you could double your rate of fire with this trigger as the time normally used to release your finger is now used to release *and* pull.

[magman007]

already been talked about, it wont work........ it is illegal




any ways, here is my new trigger idea, been cookin ut upo for a while, for the e.mag

[bowser************]

for that funky trigger u guys were talkin about, here's the link to doc's picture

http://www.docsmachine.com/galleries/rockingtrigger.jpg

and heres the pic

[Xerces]

i was thinking something along the lines of a trigger setup similar to some double barreled shotguns. have the 2 fingers set up in front of eachother. the ring design on the rear one to aid return on not reactive triggers.

heres a little pic that shows a simplified design of it.

A: a pin located stationary on the back of the main part (internal to the frame) adjusted to however the gun fires.

B: main sleeve that glides along rail C and holds the 'trigger' to the frame

c: pin holds trigger to frame, also is what the sleeve glides on.


i didn't put too much effort into my ms_paint drawing, apologize for that. if anyone thinks this might work and wants to pursue it further, you have my full permission, i'd just like to see the result =)

[paintbattler]

it could break if u put enuff pressure on the bottom of the 2x trigger