OK, this kind of connects to another thread but I figured having this open to act as a central resource and less about discussion would be beneficial. So here is the topic:
For all the various mainstream markers out right now, what are the minimum and maximum operating and cycling pressures for shooting 280fps, what is the OPTIMUM pressure levels for high cycling rate and ROF or one within human bounds (I don't care if upping the pressure 100psi can make a marker shoot 60bps, no one can shoot that), the OPTIMUM pressure level for efficiency, and any benefits or weaknesses to note for each.
So, for example, if you have tested a WGP Post-2000 Autococker document what is the minimum pressures you have had it cycling at and minimum you've had it firing 280 at, the pressure you used to meet your BPS needs, and the pressure you set it at for maximum efficiency and/or non-chopping benefits.
I think too many people overhype shooting markers at extremely low pressures but lose tons of efficiency, however taking that same marker and upping it a couple dozen psi or using a different mod may allow extreme efficiency, less leaks, etc. Having that input available for everyone may be beneficial. Thank you.
For all the various mainstream markers out right now, what are the minimum and maximum operating and cycling pressures for shooting 280fps, what is the OPTIMUM pressure levels for high cycling rate and ROF or one within human bounds (I don't care if upping the pressure 100psi can make a marker shoot 60bps, no one can shoot that), the OPTIMUM pressure level for efficiency, and any benefits or weaknesses to note for each.
So, for example, if you have tested a WGP Post-2000 Autococker document what is the minimum pressures you have had it cycling at and minimum you've had it firing 280 at, the pressure you used to meet your BPS needs, and the pressure you set it at for maximum efficiency and/or non-chopping benefits.
I think too many people overhype shooting markers at extremely low pressures but lose tons of efficiency, however taking that same marker and upping it a couple dozen psi or using a different mod may allow extreme efficiency, less leaks, etc. Having that input available for everyone may be beneficial. Thank you.