Question for Solidworks users.

[luke]

Is it possible to save a part without

[luke]

Does anyone know how to change the back ground color of the page?

[Smoothice]

i know nothing about solid works.

Is the logo a separate layer or is it part of the background?

[MoeMag]

Try this first...


Then if that doesnt work go to... Tools > Options



Hope that works. If not LMK!

[luke]

Another question, how do I get rid of the white parts of my drawings? I've tried to select them individually but the program won't allow it. Is there anyway to clean it up?

[MoeMag]

Thats a preformance issue. You might be able to go to= Tools>options> system options tab>preformance>curvature generation and set that higher.

Other than that look into a graphics card.

...unless you modeled your curves with straight lines.

[luke]

Thats a preformance issue. You might be able to go to= Tools>options> system options tab>preformance>curvature generation and set that higher.

Other than that look into a graphics card.

...

Thanks, That did it! Damn your good.

unless you modeled your curves with straight lines.

Nope

[luke]

Where is the lighting control?

I've seen it before but don't remember where.

[MoeMag]

Red ellipse this time.

Click on it and it will open up the lights. It has an ambient and two spots usually. You can position the spots, and add more I believe.

Select each light and you can manipulate its position, color, and intensity.

[luke]

Red ellipse this time.

Click on it and it will open up the lights. It has an ambient and two spots usually. You can position the spots, and add more I believe.

Select each light and you can manipulate its position, color, and intensity.

Damn that was right under my nose, it's been awhile since I used this program. Thanks for the help.

[luke]

Thanks for the help wouldn't have it finished up without your help.
Here's one of the finished projects, much better than what I had. (Header for my website)

[luke]

[luke]

I got it, never mind.