Fun with paint.

[Dubstar112]

I took the hopper off of loads sfl, still needs a lot of work, but you can see where im heading..

Well, if you can see, your better than I. Cause I dont know why I did it, other than to see how far I could go.

[Dubstar112]

how about a single I frame? Paint is my favorite program.

[HoppysMag]

check out my 3d rendering of tom

[Load SM5]

Give me back my hopper, you tool!

[FalconGuy016]

did you actually take the time to cut the picture out by hand?

[Dubstar112]

The hopper? No, I just copied the wood grain and went over it by panneling. Then I had to make a fence board from scratch because the hopper blocked part of it, and it was a wierd color, so I went deeper. I get bored somtimes. I have done a couple nice ones. Ill see if I can dig them up.

[TransMan]

U do a lot of barrel taging load??

[Load SM5]

It's only a 14 inch barrel. The camera angle and the fact that the Edge kits have shorter control bores that most 2 pc barrels make the thing look long.

[Dubstar112]

Stab somone now! Took me a few to figure out how to make it right, but MSPAINT always comes through