Level 10 email from non AO savvy customer.

[Potatoboy]

I just wanted to share this with you guys. It's an email from one of the customers in the shop I work at.

Bold sections are my clarifications, and I did remove a little bit of the email out regarding a new reg piston assembly, since his mag vents on anything but the gold spring.

"Played at Killer's field for the first time on 05-04-03 the day after you installed the LVL 10 on my Mag.. NOT one ball break out of a whole case of X-BALL {Nelson Challenger seconds}.... {...} Thanks again for taking the time to work on my mag.

Shawn."

[Army]

Doesn't that make you all tingly inside Tato?

That happens at my local shop too, after I install LX or Warp Feeds. "Gush gush gush! thank you!"

Ahhh, the goodness that is AGD

[Cryer]

Re: Level 10 email from non AO savvy customer.

The other day at the field, a guy asked if I could set up his Imp like my Intelliframe (where the trigger is wired to the hopper)

Originally posted by Potatoboy
.... {...}

I don't know why but that is hillarious!

[sneakyhacker420]

Re: Re: Level 10 email from non AO savvy customer.

Originally posted by Cryer
The other day at the field, a guy asked if I could set up his Imp like my Intelliframe (where the trigger is wired to the hopper)

just splice the wires going into the imp solenoid and connect them to the revvy

[Cryer]

Re: Re: Re: Level 10 email from non AO savvy customer.

Originally posted by sneakyhacker420

just splice the wires going into the imp solenoid and connect them to the revvy

I knew there was a way, but I had never even seen the inside of an imp.
Plus I was worried about the current: If I made a circuit between the noid and the Revy motor, would that mess with the current of the 2 seperate power sources?