PBX body number 2

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • captian pinky
    Bearded Works

    • Oct 2004
    • 2755
    #1

    PBX body number 2

    so i got the body in finally after it was sent to my house 4 hours away and then was mailed to me at school. upon arrival i noticed the rear hole for the on/off pin has been broken. is there anyway this can be repaired? is welding it closed an option?



    Tags: None
    • Levi
      Registered User
      • Mar 2013
      • 249
      #2
      That's an awfully thin piece of aluminum to try to weld. I would think that the chances of doing more harm than good are fairly high here.

      Isn't this completely hidden anyway when the marker is assembled? I would be tempted to just file that little piece of metal away (turning the hole into a slot) and call it a day if it were me.

        Comment

        • Nobody
          Nobody's Perfect
          • Oct 2001
          • 3384
          #3
          yes, it would be a problem welding it. you would have to spot it, then clearance the hole for the sear, clearance the valve and clearance the rail. it would be possible to braze it, which would fix it, but brazing is a lost art and it might not be a total fix, i.e. it could break again. it is an extremely thin area to fix, and that i don't believe that even if it wasn't fixed, it shouldn't be a problem.

            Comment

            • athomas
              Of course it works-its AGD
              • Jan 2002
              • 8039
              #4
              I wouldn't worry about it as is. Its hidden. If you are worried about it interfering with the on-off at some future time, then preemptively file it into a slot as mentioned previously.
              Except for the Automag in front, its usually the man behind the equipment that counts.

                Comment

                Previous template Next
                Working...