What happened to the site ?
What happened to the site ?
Nothing? I can get on.
There is no https, so maybe you have a cached version with a bad public key? IDK, clear your cache and try again. If that doesnt work, try your phone over the cell network. If that doesnt work, write a strongly worded letter to Andrew stating you demand his Automag single trigger frames to be done in the coming month.
It's working?
Seems fine to me, last update was 2020 so... All is normal
Sent from my motorola edge 5G UW (2021) using Tapatalk
Looks like a home made site from 1996, doesnt look the same, phone or PC ?
I hear through the grapevine that there is a new frame coming from someone you all know and trust. I would save my money...
You have my interest duly piqued. I'll most probably buy one.
Hrm, a Magnus gas-through frame? I'm intrigued. Tunaball '22 reveal?
Darn, I thought it was going to be the uniframe BigEvil teased with a rendering back in 2012...
https://www.automags.org/forums/show...27#post2798027
>>WTB<< Sydarm w/ constant air__WarpedMephisto half-c/f body__Ac!d c/f trigger__TASO humpback frame__an Oh-Mag
I've had rail-less on my mind this year and screen grabbed that years ago along with those 'Cocker hinge-frame conversions. One would be perfect with XMT's ULE bodies.
I always thought it'd be cool if a gas-thru frame had an upward extension on the right side of the tang next to the thumbscrew hole. Like a tombstone. The top of this tombstone would have a banjo hole to accept a quick-strip banjo bolt going straight into the valve. A 1/8" NPT insert/plug drilled and tapped to accept the RT banjo bolt would be super convenient. Biggest drawback to that additional hunk of aluminum would be aesthetics with some body/rail combos and overall rail compatibility - no rear winged RT Pro, Emag, most RPGs... But if the tombstone was a bolt-on affair there could be versions that swung out further to clear various rails.
Or maybe a Nummech N-Mag just needs a "bridge" on the N-Mag frame that takes a small thumbscrew banjo bolt at the valve for tool-less disassembly. A more permanent version of the double CCM fitting setup most seem to run.
that is basically was done with the ccm fittings. which i guess could be done as a single piece but really the hard part is getting the fitting heights right.
Any news on those bodies? Did they ever come out?
..... Any specific body? He has multiple
I'm waiting on the n mag frames
Sent from my motorola edge 5G UW (2021) using Tapatalk
I can't remember the names off the top of my head, but any of them. I saw a small trickle of these over the last few years, but I was wondering if Andy ever released them to the masses. I'm not on facebook so I don't really check too often, but I dont think I ever saw them officially release yet.
I was worried about it for a while until I saw the autococker parts come out last year. So nummech lives on.
I really hope the automag parts become available again. I feel that there is a lot of pent up demand for his stuff or at the very least more gas through frames.