Originally Posted by
OPBN
I can swap out a different on/off, but it just seem like it's either tripping the noid consistently or something. I take the battery out and put it back in and it kinda trips it a little, but slowly almost dies.
I tested the battery and its putting out 9+ volts. Could it be that the capacitor has been sitting uncharged for so long that it might need to charge for awhile before it will work? I know I had something similar happen on my VER frame. It sat with a dead battery in it for like a year. Took it out and replaced it and it took it a few minutes to start working again.
There is something in the manual about there being a service mode and you can adjust how hard the noid strikes the sear, but I can't figure out how to get it into service mode. All I see in the manual is how to change rate of fire etc.