In need of a pro tune job?

[MANN]

Thanks MANN, I'm mostlikly going to send to a tech. don't care how long it takes.

If you are going to do that Tuna is probably your best bet. If you have any questions feel free to pm me, and Ill try to help.

[Dr.Demo]

im just waiting on a reply from tuna...

[Smoothice]

how did you contact him?

I had good luck going to his website www.tunamart.com and sending him an email from there. I think it is under contact.

[Ruler_Mark]

"One thing i have noticed is the bolt does not travel over the power tube very well, and there is some marks on it from the pre. owner."


Still wondering what thoose marks are.

Tuna will set you straight no matter.

[mr doo doo]

so you havent tried that tightening thing? if that method works, it wont endanger stripping the screw. all you do is air up your gun, shoot until the sear would not reset, then tighten the filed strip screw until the sear resets back. you arent even tightening it A LOT, just a little bit after hand tightened. try this first before sending and waiting awhile to get it back.

[Dr.Demo]

"One thing i have noticed is the bolt does not travel over the power tube very well, and there is some marks on it from the pre. owner."


Still wondering what thoose marks are.

Tuna will set you straight no matter.

well it looks like someone tried removing the power tube from the valve and gripped it by the power tube. Not too sure.

[Ruler_Mark]

well it looks like someone tried removing the power tube from the valve and gripped it by the power tube. Not too sure.

can you take pictures?


and by screwed i meant if the bolt is damaged you'd have to get a new one of thoose which arent cheap like an oring.