I have done a lot of cleaning in the valve/reg I have never done before, so I am excited to see how my consistency will be affected. If it is still bad I will order an o-ring kit, if not I will delay that purchase, but not by too much.
Funny though, when I installed my ULT i was able to make it go into 'rapid-fire' (Trigger bouncing to fire) by going up to 5 or 6 shims, but I dropped the shim count by one as I liked to walk it, and it was easier to walk very reactive. (You could kind of get the trigger to bounce but it was very slow) After I clean my gun and aired it up, it was going into rapid fire easily, and my on/off is the ONE piece in the gun I didn't touch. First I will chrono it to see if low velocity is causing it, otherwise I will have to take out a few more shims.
Funny though, when I installed my ULT i was able to make it go into 'rapid-fire' (Trigger bouncing to fire) by going up to 5 or 6 shims, but I dropped the shim count by one as I liked to walk it, and it was easier to walk very reactive. (You could kind of get the trigger to bounce but it was very slow) After I clean my gun and aired it up, it was going into rapid fire easily, and my on/off is the ONE piece in the gun I didn't touch. First I will chrono it to see if low velocity is causing it, otherwise I will have to take out a few more shims.
Comment