drop off on X'ed Pneumag ???

[chafnerjr]

WELL that sucks Can you help me with my X-valve problem

Yes... you probably have to replace all of your o-Rings One quick x-valve rebuild kit and you should have that nasty CO2 problem all sorted out! Oh... and make sure your using HPA...

Now if I understand you correctly and you still have issues after take a look at cyberave68's magnet mod for the trigger return. Perhaps the MSV-2 isn't able to push out the lever and is essentially short stroking.

[211]

is the on/off pin bent?

[Spider-TW]

Did you put shims in your ULT already?

I had one with a very tight top oring that would just grab the pin and not let go. I put a buna oring in it, which lasted long enough for me to decide I didn't like the trigger pressure (too light).

[big poppa fluff]

Did you put shims in your ULT already?

I had one with a very tight top oring that would just grab the pin and not let go. I put a buna oring in it, which lasted long enough for me to decide I didn't like the trigger pressure (too light).

that just the problem I didnt get any spare parts with this x-valve(buy the wat I didnt realy put CO2 to it I was just wondering). So what part would you recomind me buy to fix my ULT problem? and where can i get them?

[big poppa fluff]

No help to where I can get the parts I need huh??

[kcombs9]

No help to where I can get the parts I need huh??

http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=458&categoryID=16

[Spider-TW]

Missed that, sorry.

also try http://store.airgundesignsusa.com/in...&categoryID=38

But the valve kit is good for general upkeep. There's always the AGD store, tunaman, themagsmith, and even a few things at actionvillage on occassion. The BST here on AO is very good if you have the time to lurk around.