Predator morlock board in E-mag

[kcombs9]

Anyone have any experience with a Predator morlock board in an E-mag?...

LED comes on but wont seem to fire. I think the Batter isn't charged completely cause the solenoid seems to only pull once then I have to pull it back up to pull down again when trigger is pulled

[211]

Is it aired up?
if not, the solenoid wont reset

[kcombs9]

Is it aired up?
if not, the solenoid wont reset

It was aired up.

[211]

Does it work right in mech mode?

[kcombs9]

Does it work right in mech mode?

works great in Mech mode. been playing like that for last 2 months cause I didn't have a charger

[kcombs9]

Seems like the solenoid dosnt have enough force/power to pull the sear... This could be due to low battery? or bad battery?

[Madmarx]

Get a tester on the batt and see.
Does the sear and noid move freely or does it bind at all?

[DevilMan]

Sorry I can't help with your fix.... but can you get me a picture of the set up you have for the internals and how the board is mounted... or is it just in there?

DM

[kcombs9]

Sorry I can't help with your fix.... but can you get me a picture of the set up you have for the internals and how the board is mounted... or is it just in there?

DM

Ill get you some pics soon.

got a tester from a friend and it seems to only be putting out about 9V's so either my getto charger that I made isnt getting it charged well enough or my batter isnt taking the charger.

Either way My z-grip mag sold and I just got the PP for that so anyone got a cheap charger and battery for sale?

[kcombs9]

2 zip ties hold it in place and there is a piece of foam of some sort protecting it and giving it some padding.

[kcombs9]

got a proper charger and battery tested at 19.19v and gun fires fine! now if it would just stop raining...

[athomas]

When I used the predator in my emag, I found I had a hard time keeping it from going full auto due to the solenoid inducing a magnetic pulse on the HES when the solenoid disengaged at the end of the dwell time.

[kcombs9]

When I used the predator in my emag, I found I had a hard time keeping it from going full auto due to the solenoid inducing a magnetic pulse on the HES when the solenoid disengaged at the end of the dwell time.

how did you fix it? only full auto I see happening is I think the seer arm for M mode is bouncing the trigger causing some some rt affect when I try and walk it. I out ran my warp with halo B and chopped a ball (really cheap paint) with the lvl 10...

[BigEvil]

Judging from the pic, it looks like the noid plunger may be out of adjustment. If its too short, the noid will have a tough time pulling it.

Also, check the dwell setting on the board. Should be 15-30 ms.

[kcombs9]

Judging from the pic, it looks like the noid plunger may be out of adjustment. If its too short, the noid will have a tough time pulling it.

Also, check the dwell setting on the board. Should be 15-30 ms.

Seems to have no problem shooting the gun in Emode now that I shortened the Mmode sear rod. But yes they both could be out of adjustment.

Can't seem to get programing to change anything... and yes the turny lock is off I get into programing but can't change any setting it seems anyone have a good manual on these? only got this so far http://www.zdspb.com/tech/km2board/p...ockmanual.html But can't seem to get it to change even fire mode