Predator morlock board in E-mag

[BigEvil]

Seems to have no problem shooting the gun in Emode now that I shortened the Mmode sear rod. But yes they both could be out of adjustment.

Can't seem to get programing to change anything... and yes the turny lock is off I get into programing but can't change any setting it seems anyone have a good manual on these? only got this so far http://www.zdspb.com/tech/km2board/p...ockmanual.html But can't seem to get it to change even fire mode

Do you have a "Predator" Morlock or one of the older km2 Morlocks? There is a difference in programming and function. Talk to Andy (Ynda) at ZDSPB and see if he can tell what one is in that gun. Then go form there.

[kcombs9]

Do you have a "Predator" Morlock or one of the older km2 Morlocks? There is a difference in programming and function. Talk to Andy (Ynda) at ZDSPB and see if he can tell what one is in that gun. Then go form there.

will do, the guy I got the gun from says its a Predator Murlock. past that I have no clue. If I sent Andy this same pic he could tell me which one it is?

[BigEvil]

will do, the guy I got the gun from says its a Predator Murlock. past that I have no clue. If I sent Andy this same pic he could tell me which one it is?

I think so. He's great, should be able to figure it out quickly. I dont know much about those older boards, but he will point you in the right direction.

[athomas]

I have two Predator II boards. They don't look like the one shown in your emag. I suspect you have an older Morlock board. The Predator II boards use surface mount LEDs and it looks like my boards might be a bit smaller as well. It is possible that your board is flashed with predator code.