this may be a stupid question, i got my freak in yesterday and i noticed the incerts fit in very tightly, is this normal? and how would I get them out? the back is also SS
-
"Im crazy newspaper face!!! gimme some candy!"
-
I Oiled the o-rings inside the barrel, with the inserts out, that helped a lot.
later HillsNVE-mag
Certified Airgun Tech.
-
Usually...
Well its supposed to fit snug but if you can't get it out then try some oil.
Comment
-
Don't worry it will stretch the oring on the inside of the barrel and they will be easier to get in and out. To get it out just put the tip of your finger in and bend it and pull. That should take it out.Famous SEAL quotes:
"Give us your mind, and we will take care of your body"
"We aren't superman, he does things the hard way. Why leap tall buildings in a single bound, when you can blow it up and walk over the rubble"
"Pain is just weakness leaving the body"
"It is not my job to judge our enemies, that is God's job, it is my job to arrange the meeting"
"I will treat you all the same, JUST LIKE CRAP!"Comment
-
keep your inserts oiled and your finger will pull em out no prob I never have had a probZ-griped, warped, retromag with super bolt, and warpleft polished body, freak kit and flatline 3kComment
-
I just bought one too and noticed the same thing - a drop of autolube on the rings and it was fine.The gelatin on the stainless like the diamond on the vinyl.Comment
-
ok,
thanx guys"Im crazy newspaper face!!! gimme some candy!"
Comment
Comment