Air Leak down barrel from e mag valve??

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Ms54Coupe
    Registered User
    • Aug 2009
    • 105
    #16
    Ok...

    I split my valve/reg apart and oiled o rings and metal/metal parts. I put the valve back together and aired it up and it jumped into RT much better and the leaking was certainly reduced but not eliminated. I was able to find that by holding the trigger back the leak would stop. Based on above post it would appear the leak is coming from my power tube. I am going to remove a shim and see where that gets me and report back.

    Thanks!

      Comment

      • athomas
        Of course it works-its AGD
        • Jan 2002
        • 8039
        #17
        Originally posted by Ms54Coupe
        I am going to remove a shim and see where that gets me and report back. !
        When testing for leaks, remove them all.
        Except for the Automag in front, its usually the man behind the equipment that counts.

          Comment

          • Ms54Coupe
            Registered User
            • Aug 2009
            • 105
            #18
            I noticed that the power tube had 2 shims in it when I pulled it apart...I put it back together with only one shim but have not aired it up yet (i'm fresh out). I am going to air it up with one shim and if there is still a leak I'll drop down to none.

            I should have my gas thru fore grip this week so I will finally be able to air up using my final setup including the adjustable max flow (currently stuck on the "on" position : ( )

              Comment

              Previous 1 2 template Next
              Working...