Center Feed Barrels

[markalex13]

I recently purchased a J&J ceramic barrel for my e-mag. The grooves on the end of the barrel are for a left or right feed mag. Mine is a center feed. The barrel goes straight in, i can't turn it or the hole is mis-alligned. As of now i have already played one game with simple sticking the barrel in and not turning it. Is this acceptable. I was thinking of drilling a samll hole at the end of the verticle groove so the pin can lock in. Any advice.

[Predater]

you could do that and then fill the gruve in whare the barrel turns so it cant get off centered. Just be carefull not to pull the barrel out in a gaim. Or at any other unintinded time for that matter.

[EnW]

Contact damageinc54 he is on the forums here.
He is a machinist and has milled a number of barrels for centerfeed guns. He can tell you all you need to know.

[markalex13]

i was also thinkin of just getting a new mainbody because i eventually want to get a warp-feed. How expensice is a mainbody?

[Predater]

markalex check in the agd store. it sells main bodys.

[markalex13]

are they ****ting me 230$ for a mainbody?

[Predater]

the machines used to cut the mainbody of the pro and e mag is very expencive. Tom tolked about it in another post. thats why they are that expensive. if you dont like the price stick with your mainbody. i couldnt help but to point out the oveus