Emag problems

[M600]

used my emag for the first time yesterday in a game
in mech mode it would "short stroke"?, basically it would leak a small amount of air after every shot unless i pulled the trigger all the way forward
in e mode it chopped a lot of balls..
so for most of the day i used it in mech mode and it performed fine as the games were short, so i could fill up on air between
any suggestions as to how i can fix this problem?
thanks

[Ando]

You have a lvl 10?

Also. Ck your bolt spring. If it's flushed or close to the bolt face then you need to replace it.

[M600]

well i only have 2 springs, on red and one unpainted
the unpainted spring is a lot worst than the red one
and yes its level 10 with an xvalve

[athomas]

Tune your level 10. Remove the shims first. Then use the largest carrier size that does not produce a leak. Always use the same white powertube carrier oring when testing different carriers. Its the carrier oring inside diameter that you are adjusting.

[M600]

ive never tuned my level 10 before
inside there are no shims but i cant fit any in there :S

[M600]

ok scratch what i said earlier
now ive tried various carriers and now it just has a massive leak down the barrel
its not the the power tube oring as i changed it and it doesnt leak when i hold the trigger down...
any ideas?
this is really starting to drive me mad

[Ando]

Your doing something wrong then. If you hold the trigger down and it stops, it's not your on/off It's the bolt. Make sure you have all the orings installed including the thin black one that goes around the top of the carrier and that your installing it in the right way.

[M600]

ok all done, just turned out i needed to remove a few shims
thanks

[maniacmechanic]

this is really starting to drive me mad

ok all done, just turned out i needed to remove a few shims
thanks

see , it's not that hard is it ?

[M600]

yeah it really isnt, just wanna thank everyone again for the help
it turns out all you really have to do is read tom tech tips ^^