E-Mag Problems

[paintball-lizard]

Hi guys just got my new battery for my emag but i cant seem to get it to work in electronic mode the soloniod doesnt seem to work S/W is 1.37any help would be great guys

[thecroatiansensation]

buy a new solenoid.

[athomas]

Probably just needs the trigger and HES setup properly. Adjust the trigger stop first so that you get the trigger pull that you want. Then adjust the HES trigger magnet to activate within the trigger movement that you have. Make sure your trigger magnet is attached in the proper orientation. If it is backwards, it will not work.

[paintball-lizard]

Thanks i will give it a try

[paintball-lizard]

Ok got the trigger set up i want but the HES magnet is missing anyone have 1 i could buy shipped to the UK?

Thanks

There was 2 in the rail i tried using 1 of them but nothing happened.

[athomas]

To start, back the trigger screw out as far as it will go. Put the gun in manual mode so that the trigger will move past the stop point of the trigger stop. Place the magnet on the trigger adjuster. Take out the valve. Turn on the gun. Hold your finger down on the on-off part of the sear to put it in the reset position. With the magnet attached to the trigger, pull the trigger in. The solenoid should click. With each release, push the sear back into place with your finger. If the solenoid does not activate, reverse the magnet and try again. If it does activate, turn the gun to electronic mode. Adjust the trigger magnet so that the trigger pull activates the electronics within the trigger pull movement.

[paintball-lizard]

ok i will try that and let you know thanks

[paintball-lizard]

Ok i got it to fire so i know the solonoid is working i just need a new trigger magnet and im good to go anyone got 1 for sale they would be willing to ship to the UK

[athomas]

You should be able to get a magnet locally. They are just neodymium rare earth magnets. Find some in the correct size and you are good to go. The trigger magnet is the same as the one you are using now.

[paintball-lizard]

Ok guys got it sorted thanks for the help (please delete)

The size of the magnet is 6mm by 2 mm