when ever i try ripping my mag in e mode it always chops, even though in mech mode it shoots flawlessy, whats going on?
its got an xvalve and lvl 10
any help appreciated
its got an xvalve and lvl 10
any help appreciated
-
-
Xmod? If so what are your settings? -
its just agd 1.37
just on semi 10 bpsComment
-
Your main bolt spring is what governs how gentle the bolt is on paint and a lvl 10 doesn't differentiate between Mech and E-Mode. It should work as advertised in either mode.
Even if something was off in the lowers, the lvl 10 should just trip over and over. Replace your bolt spring and try it out again.
After a bolt spring wears down, the marker will still function (usually) but the lvl 10 will act like a 7 which will not stop on a jam. Just toss a new bolt spring in there (preferably the red or gold spring) and see if your still blending.
Do you happen to have a powerfeed body? If you have a bad PF plug, that will cause blending issues or activate a lvl 10 at an annoying rate.
A properly setup lvl 10 should/will alleviate 99% of chops.Last edited by Ando; 03-20-2011, 11:05 AM.Comment
-
ok its probably my spring then
does anyone ahve any for sale? cause i cant find any in the uk...
thanksComment
-
Is it chopping or are the balls breaking in the barrel?Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Originally posted by M600
http://cgi.ebay.co.uk/AUTOMAG-MAIN-S...item5889175e0a
these are the ones i mentioned on p8ntballer palComment
-
thanks mate
much appreciatedComment
Comment