EP sleeper mag

[renie]

micro rocks are the most stable and will take 1100 psi all day long :)
or you could do someting simular like i did on my egomag using a hp reg as a lpr

[hill160881]

You know a bike grip might fit over some HPRs. That would remove the T fitting at the valve. Good idea!

[93klauss]

Air line

So I think my plan is to run a remote to the valve and then T it to the front grip. Anyone know where I might find a T fitting that is threaded for SS lines? Are they even made?

[rawbutter]

So I think my plan is to run a remote to the valve and then T it to the front grip. Anyone know where I might find a T fitting that is threaded for SS lines? Are they even made?

Palmer's Pursuit Shop has them. You can get them in brass or nickel.

http://palmer-pursuit.com/cart/index.php?main_page=product_info&cPath=141_1_10&products_id=15

If you're gonna go brass, though, you might as well swing by Pep Boys. They have them there for about $3.

And you can get the rams from airsoldier.com

http://www.airsoldier.com/mm5/merchant.mvc?Screen=PROD&Store_Code=AOS&Product_Code=CLIPPARD-MPA-3&Category_Code=FITTINGS

[93klauss]

Palmer's Pursuit Shop has them. You can get them in brass or nickel.

http://palmer-pursuit.com/cart/index.php?main_page=product_info&cPath=141_1_10&products_id=15

If you're gonna go brass, though, you might as well swing by Pep Boys. They have them there for about $3.

And you can get the rams from airsoldier.com
http://www.airsoldier.com/mm5/mercha..._Code=FITTINGS

Thanks a lot!!
I think I have all the resources I need!!

Now for the build, might wait for winter but I don't think so!!