AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
By looking at the diagram AGD has on there web site I found were they added the restriction drilled it out in about 5 sec, just matched up the drill bit up to the tube size and then went down one size on my bit drilled it out problem solved. Thanks for the help.
Could you show where you find this diagram because I couldn't find
Comment