Macroline and Fittings on Nummech Frame

[jbtamu1011]

I need some help y'all. i have the ccm fittings with the regular and extended posts. It doesn't look right. What's the best way to get it connected?

[Gundam V]

From what is shown in the picture. The extended post should be on the trigger frame and the standard post should be on the valve.

Sent from my SM-G970U using Tapatalk

[jbtamu1011]

From what is shown in the picture. The extended post should be on the trigger frame and the standard post should be on the valve.

Sent from my SM-G970U using Tapatalk

I do have the extended on the trigger frame. Ill switch the valve one to the standard to see what happens.

Is there a good method to bend the macroline easier or more evenly?

[Tunaman]

I thought you were supposed to point them at each other and put like a 1" piece in there?

[jbtamu1011]

I thought you were supposed to point them at each other and put like a 1" piece in there?

The instructions show either facing each other as you mention or a small arch of line between the fittings. The only way i could point the fittings at each other would be to mill off the rear wings of the rail.

[jbtamu1011]

I have it like this now. Doesn't seem to be much in the way of my thumb and hand.

[Gundam V]

If you look at nummech picture on his site showing off the trigger frame. He also uses an rt pro rail to show it off. Have you tried making a slight adjustment forward when looking at how he set his up to get around the rear rail wings.

Sent from my SM-G970U using Tapatalk

[jbtamu1011]

If you look at nummech picture on his site showing off the trigger frame. He also uses an rt pro rail to show it off. Have you tried making a slight adjustment forward when looking at how he set his up to get around the rear rail wings.

Sent from my SM-G970U using Tapatalk

I did not notice that before. I'm wondering if I have to use those type of fittings instead of the CCM one's that I have on in the picture. The CCM fittings seem to be a bit shorter in height than the normal fittings.

[AnthonyW]

Use about half the macro & take fittings off leaving the posts on. Connect the macro to each fitting & then bolt each one to the post on frame & valve [emoji6]


Sent from my iPhone using Tapatalk

[jbtamu1011]

Use about half the macro & take fittings off leaving the posts on. Connect the macro to each fitting & then bolt each one to the post on frame & valve [emoji6]


Sent from my iPhone using Tapatalk

Not sure what I'm doing wrong, but it's not working on with the CCM fiittings. short post is on the valve. longer post is on the trigger frame.

[jbtamu1011]

Well had to go this route. Have to have fixed on valve and swivel on frame. No leaking. Can you anno these fittings? Or just spray paint?

[Tunaman]

Is that an idiot mark I see on that valve?

[Gundam V]

Is that an idiot mark I see on that valve?

lmao, c'mon tuna. It gives the valve a little character.[emoji13][emoji13][emoji13][emoji13]

Sent from my SM-G970U using Tapatalk

[knownothingmags]

Is that an idiot mark I see on that valve?

lol i was going to say the same thing.

[jbtamu1011]

Hey now. The valve is not where the attention should be. No wandering eyes in this post. Damn, barely noticeable in person. I'm sorry Tunaman. :facepalm: