Switched rails now having issues

[luke]

I'm having some strange issues with mine too. Had a tac one that was functioning perfectly and switched to the full length tac one looking rail. The trigger rod stuck out further so that there was no space between the rod and trigger (intelliframe; stock blade trigger). After adjusting the rod so that there is a tiny gap, the gun won't shoot. I don't think it is pushing the on/off pin in enough. Need to buy and try out a longer on/off pin and see what happens.

Is your rail a Hybrid Rail?

[luke]

The Hybrid rail is essentially an Automag rail so the trigger rod shouldn't change.

[luke]

Sounds like your trigger rod is still incorrectly adjusted.

[RossT]

I'm having some strange issues with mine too. Had a tac one that was functioning perfectly and switched to the full length tac one looking rail. The trigger rod stuck out further so that there was no space between the rod and trigger (intelliframe; stock blade trigger). After adjusting the rod so that there is a tiny gap, the gun won't shoot. I don't think it is pushing the on/off pin in enough. Need to buy and try out a longer on/off pin and see what happens.

[luke]

Hello, I went from a stock rail to a Luke's costume gamma rail and now when I gas up the gun, x Valve it goes crazy just shooting . Have a nummech trigger with an intelliframe if any of that matters. any help would be very much appreciated.

Did you get it figured out?

[Fred]

Or use a rail that follows AGD spec...

[Nobody]

Or use a rail that follows AGD spec...

[luke]

You need gap between the sear rod end and back of the trigger (when aired up) about the thickness of a credit card

[PhrostPhreek01]

update: switched rails back. i believe its a sear adjustment issue i think i had it to far in on the lukes rail which caused it to stick. going to switch it again. and probably have to adjust it some more. will give another update when i do . thanks everyone for the input

[rawbutter]

I would first go back to the stock rail and make sure everything still works right like that. It's possible something else is going on, and the rail change is just a coincidence.

If everything works right with the stock rail, I would then look at the gap between the trigger and the sear arm. There should be a small gap (about the width of a credit card) when the marker is aired up. Otherwise the trigger can cause problems.

[PhrostPhreek01]

Did you install the rail bushing when you switched out the rails?

Yes

[luke]

Did you install the rail bushing when you switched out the rails?

[PhrostPhreek01]

Hello, I went from a stock rail to a Luke's costume gamma rail and now when I gas up the gun, x Valve it goes crazy just shooting . Have a nummech trigger with an intelliframe if any of that matters. any help would be very much appreciated.