Bad Neighbors. Warp feed and my right hand.

[cphilip]

OK then I will leave them all to you. I'll PM you when I see one!

[Patron God of Pirates]

OK, but lets say I'm neurotic and still want to have the option of switching hands, has anyone tried making a longer mounting plate? Is there any reason you can think of why this would not work?

Also, is there any way around melting a groove in your hopper to accommodate the feed hose?

PS- Thanks for all your help, I truly appreciate it.

[synreal]

If you still want the option of switchings hands, tilt your warp out to a wider angle to give allow more room on both sides of the grip

My setup fits just fine without having melted the hopper shell.

[the JoKeR]

Originally posted by Patron God of Pirates
OK, but lets say I'm neurotic and still want to have the option of switching hands, has anyone tried making a longer mounting plate? Is there any reason you can think of why this would not work?

Also, is there any way around melting a groove in your hopper to accommodate the feed hose?

PS- Thanks for all your help, I truly appreciate it.

The only thing I can think of that might cause a problem with a longer plate would be related to the vibration sensor, but I'd guess that a longer plate would cause more vibration, so this shouldn't be an issue. You can melt a groove in the side of your hopper, or cut a 1" hole in the top and bottom and run the hose right through the hopper. I did this because I think it looks better. It's a little harder to clean it after getting hit there, but I'll live.

[cphilip]

I found drilling it is much neater and locks the Revy onto the whole set up much much better. One inch hole saw. But be sure you are finally exactly where you want it for good. Revy halves are $5 so no biggy if you later change your mind.

[Patron God of Pirates]

Cool, I just ordered my Intelliframe (Chrome w/blade) and I'll be wiring the warp direct, so vibration wont be an issue.

I like the idea of cutting the 1" hole much better.

[FrAuStY]

I have a question and now seems like a good time to ask it.. Where can I get just the shell of the revvy? My friends cracked and I was gonna split the cost of a new one with him but chphilip said they're only 5$.. where do I get them for this cost?

[synreal]

most proshops carry them in atleast black and clear or 888paintball has them for $6.88 - http://www.888paintball.com/Class.as...+MISCELLANEOUS

[cphilip]

Well..here but the shipping will get ya so order a few of them. Share em with all your friends! Make dandy soup ladels and nice Christmas presents!

http://www.dropzonepaintball.com/html/revolution.html

[than205]

Another option would be to buy a PTP warp bracket.